Concrete Patios in Murphy, TX

A concrete patio is a durable, low-maintenance outdoor living surface when it's poured correctly. We connect homeowners throughout Murphy and Collin County with contractors who install concrete patios in plain, broom-finished, exposed aggregate, and stamped finishes — with proper slope for drainage, correct control joints, and the reinforcement appropriate for the application.

Murphy sits in eastern Collin County between Plano and Sachse, a small city that has been almost entirely built out within the past three decades as DFW's northeastern suburban growth filled in what was, until relatively recently, farmland — nearly all of Murphy's housing stock dates from the 1990s through today. That recent, compressed development timeline means the city has little of the older-housing-stock variety seen in longer-established North Texas cities like Denton or Sherman; the foundation-repair picture here is almost entirely about how well individual subdivisions were engineered and graded during that relatively short building boom rather than about original construction reaching old age. Collin County's blackland prairie clay is among the most expansive in North Texas, and Murphy's small size and late, rapid development mean it shares the same fundamental soil challenge as its larger, more well-known neighbors Plano and Wylie, just compressed into a much shorter and more recent construction window.

Finish Options for Concrete Patios

Broom finish is the standard residential exterior texture — slightly rough for traction, clean looking, and durable. Exposed aggregate removes the surface paste to reveal the stone in the mix — a more textured look that hides minor surface wear. Stamped concrete uses patterned mats pressed into the wet surface to create the look of brick, slate, stone, or tile. All three options are available and we can show you samples before you commit to a finish. Color and texture aren't purely cosmetic decisions in Texas — a darker finish absorbs more heat and can be genuinely uncomfortable barefoot in direct summer sun, while a lighter broom finish stays noticeably cooler.

• Broom finish — the standard, most affordable, lowest-maintenance option; slightly textured for traction and stays cooler underfoot than darker finishes.
• Exposed aggregate — reveals the stone in the mix for a textured, natural look that also hides minor surface wear well over time.
• Stamped concrete — patterned to resemble brick, slate, or stone at a lower cost than the real material, with periodic resealing required.
• Acid-stained or dyed finish — a variegated color effect applied to the cured surface, often paired with a broom or light stamped texture.

Drainage and Control Joints

A patio that doesn't drain away from the house is a foundation liability. Contractors we connect you with slope patios a minimum of 1/8 inch per foot away from the structure to ensure water flows away. Control joints are placed to manage where cracking occurs — in a patio this size, joints every 8-10 feet in each direction is standard. Patios without control joints tend to develop random cracking within a few years. Drainage matters even more directly beside a house than out in a driveway, since a patio sloped even slightly toward the foundation instead of away from it can contribute to the same soil-moisture problems that drive foundation settlement in expansive clay.

• Slope away from the house — a minimum of 1/8 inch per foot, checked during layout before the pour, not assumed.
• Control joints at proper spacing — typically every 8-10 feet, placed to guide where the concrete cracks rather than leaving it to chance.
• Transition points — where a patio meets a step, a foundation, or an existing slab are common weak points if not detailed correctly.
• Downspout and gutter coordination — a patio poured without accounting for where roof runoff lands nearby can undermine even a well-sloped surface.

This content is reviewed by the Texas Concrete Contractor editorial team and informed by licensed-contractor sourcing, manufacturer documentation, and established industry standards for Concrete. Read our editorial standards.