Concrete Patios in El Paso, TX

A concrete patio is a durable, low-maintenance outdoor living surface when it's poured correctly. We connect homeowners throughout El Paso and El Paso County with contractors who install concrete patios in plain, broom-finished, exposed aggregate, and stamped finishes — with proper slope for drainage, correct control joints, and the reinforcement appropriate for the application.

El Paso sits at the far western tip of Texas on the Rio Grande, across the river from Ciudad Juárez, Mexico, and hard against the Franklin Mountains — a genuinely different geography and climate from the rest of the state, closer in character to the Chihuahuan Desert than to anywhere else in Texas. The city's housing stock ranges from early-1900s adobe and masonry construction near downtown to postwar and later stucco-and-block subdivisions spreading up the mountain foothills and across the desert basin. El Paso County's climate is desert-arid, with minimal annual rainfall, intense summer heat, and — unusually for Texas — real elevation change across the city as neighborhoods climb the lower slopes of the Franklins. Rocky, caliche-heavy desert soil behaves entirely differently under concrete than the clay found in the rest of the state: shrink-swell cycling is a much smaller factor here, while the desert's rare but intense monsoon-season downpours, combined with the steep grading in hillside neighborhoods, make flash drainage and erosion control the more pressing concrete concerns in El Paso.

Finish Options for Concrete Patios

Broom finish is the standard residential exterior texture — slightly rough for traction, clean looking, and durable. Exposed aggregate removes the surface paste to reveal the stone in the mix — a more textured look that hides minor surface wear. Stamped concrete uses patterned mats pressed into the wet surface to create the look of brick, slate, stone, or tile. All three options are available and we can show you samples before you commit to a finish. Color and texture aren't purely cosmetic decisions in Texas — a darker finish absorbs more heat and can be genuinely uncomfortable barefoot in direct summer sun, while a lighter broom finish stays noticeably cooler.

• Broom finish — the standard, most affordable, lowest-maintenance option; slightly textured for traction and stays cooler underfoot than darker finishes.
• Exposed aggregate — reveals the stone in the mix for a textured, natural look that also hides minor surface wear well over time.
• Stamped concrete — patterned to resemble brick, slate, or stone at a lower cost than the real material, with periodic resealing required.
• Acid-stained or dyed finish — a variegated color effect applied to the cured surface, often paired with a broom or light stamped texture.

Drainage and Control Joints

A patio that doesn't drain away from the house is a foundation liability. Contractors we connect you with slope patios a minimum of 1/8 inch per foot away from the structure to ensure water flows away. Control joints are placed to manage where cracking occurs — in a patio this size, joints every 8-10 feet in each direction is standard. Patios without control joints tend to develop random cracking within a few years. Drainage matters even more directly beside a house than out in a driveway, since a patio sloped even slightly toward the foundation instead of away from it can contribute to the same soil-moisture problems that drive foundation settlement in expansive clay.

• Slope away from the house — a minimum of 1/8 inch per foot, checked during layout before the pour, not assumed.
• Control joints at proper spacing — typically every 8-10 feet, placed to guide where the concrete cracks rather than leaving it to chance.
• Transition points — where a patio meets a step, a foundation, or an existing slab are common weak points if not detailed correctly.
• Downspout and gutter coordination — a patio poured without accounting for where roof runoff lands nearby can undermine even a well-sloped surface.

This content is reviewed by the Texas Concrete Contractor editorial team and informed by licensed-contractor sourcing, manufacturer documentation, and established industry standards for Concrete. Read our editorial standards.